JETWAY PT88AS - REV 1.0 User Manual page 19

(5) LAN Port connector: LAN
This connector is standard RJ45 connector for Network
(6) Parallel Port connector (25-pin D-sub connector): PARALLEL
(7) Serial Port connector: COM1
The connectors is 9-pin Male connector that connect serial devices to the system board.
(8) Audio Connector: CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC.
Line-out :
Line-in :
MIC :
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to your hard disk(s). If you
install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
Audio output to speaker
Audio input to sound chip
Microphone Connector
PS/2 Mouse
PS/2 Keyboard COM1
Pin 1
PRINT
USB1
FDD
Floppy Drive Connector
14
LAN
MIC
LINE-IN
LINE-OUT
USB