Advertisement
Quick Links
Advertisement
Related Manuals for Planet CS-950
Summary of Contents for Planet CS-950
- Page 1 UTM Content Security Gigabit Gateway CS-950 Quick Installation Guide...
- Page 2 Table of Contents 1. Package Contents ..................3 2. Hardware Introduction ................4 2.1 Hardware Interface ................4 2.2 Hardware Installation ................6 2.2.1 Desktop Installation ..............6 2.2.2 Rack Mounting ................7 3. Setup of the UTM Content Security Gateway ..........9 3.1 Requirements ..................
- Page 3 1. Package Contents z CS-950 x 1 z Quick Installation Guide x 1 z Adapter x 1 z Power Cord x 1 z Console Cable x 1 z Ethernet Cable x 1 z Screw Package x 1 z Rack-mount Ear x 2...
- Page 4 2. Hardware Introduction The following are instructions for setting up PLANET CS-950. Refer to the illustration and follow the simple steps below to quickly install your UTM Content Security Gateway. 2.1 Hardware Interface Front Panel: UTM Content Security Gigabit Gateway...
- Page 5 DC in: 12V DC, 3.3A power input. Console Port: A DB-9 console port (115200, 8, N, 1) to inspect internal network setting, or restore to its factory default. USB Port: USB 2.0 port for system configuration backup and recovery. ...
- Page 6 2.2 Hardware Installation 2.2.1 Desktop Installation To install the CS-950 on desktop, simply follow the following steps: Step 1: Attach the rubber feet to the bottom of the CS-950. U T M C o n te n t C S- 95 0...
- Page 7 To install the CS-950 in a 19-inch standard rack, follow the instructions described below. Step 1: Place your CS-950 on a hard flat surface, with the front panel positioned towards your front side. Step 2: Attach a rack-mount bracket to each side of the CS-950 with supplied screws attached to the package.
- Page 8 Step 4: Follow the same steps to attach the second bracket to the opposite side. Step 5: After the brackets are attached to the CS-950, use suitable screws to securely attach the brackets to the rack, as shown in the picture below.
- Page 9 3.2 Logging in to the Security Gateway Then refer to the steps to configure the CS-950: Step 1: Connect the IT administrator’s PC and CS-950’s LAN port (port 1) to the same hub / switch, and then launch a browser to link the management interface address which is set to http://192.168.1.1 by default.
- Page 10 3.3 Setting the LAN/WAN IP Interfaces Step 1: Click on Network > Interface > LAN (Port 1) to configure the LAN settings. Lastly, click on “Save” to complete the setup. Step 2: Click on Network > Interface > WAN 1 (Port 2) to configure the WAN settings.
- Page 11 4. Appendix Appendix A: Default Setting Default IP Address 192.168.1.1 Default Login User Name admin Default Login Password admin Default DHCP Server Default LAN Port Ethernet Port 1 Default WAN Port Ethernet Port 2 Appendix B: User’s Manual User’s Manual...
- Page 12 PLANET directly at the following email address: support@planet.com.tw. Copyright © PLANET Technology Corp. 2017. Contents are subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners.
Need help?
Do you have a question about the CS-950 and is the answer not in the manual?
Questions and answers