Summary of Contents for Silvan Selecta REDLINE SPOTPAK 25
Page 1
Instruction Manual MANSP55 REV N 17/10/24 REDLINE SPOTPAK 25, 55 & 100 12V AND RECHARGEABLE SP100-R2, SP55-R1, SP55-B2, SP25-R1, SP25-B2 & SP25-TR3 VICTORIA (HEAD OFFICE) NEW ZEALAND SILVAN SERVICE SUPPORT: PH 1300 745 826 (AUST) Telephone: +61 (03) 9215 2700 Hamilton, New Zealand PH 0508 745 826 (N.Z)
Page 2
Warranty Silvan Warranty Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Page 3
Safety Information Before attempting to operate or install the sprayer carefully read and take note of the following safety warnings. Failure to comply with these warnings may result in serious injury or death. Warning! This sprayer is designed and manufactured solely for the purpose of applying agricultural chemicals to plants.
Page 4
Specifications GENERAL The Silvan Spotpak is a compact portable sprayer designed for spot spraying. Whether you are a commercial grower, or a home gardener you will find many uses for this unit. The tank pump and wand fittings are corrosion resistant and are suitable for applying liquid herbicides, insecticides, fungicides, organic and green formulations.
Page 5
Assembly GUN ASSEMBLY Fit the spray trigger and nozzle tip to the lance as shown below. Ensure the O-rings are in place. Long end inserts into trigger Short end inserts into nozzle GUN CLIPS Fit the 2 Gun Clips to the side of the tank with the supplied screws. (*NOT REQUIRED ON SP25-TR3 TROLLEY) FITTING TROLLEY HANDLE (TROLLEY VERSION: SP25-TR3) Unscrew lobe from frame and insert handle with hole facing outwards.
Page 6
Assembly CONNECTING TO 12VOLT DC SUPPLY (25L, 55L and 100L VERSIONS: SP25-R1, SP55-R1&SP100-R2) The Sprayer requires a 12-volt DC power source. A three-metre loom is provided with the sprayer to allow the sprayer to be connected to the 12-volt DC source available. The brown wire is positive, and the blue is negative.
Page 7
Setup And Testing It is always recommended that you first test all spray equipment thoroughly with clean water. 1. Be sure to wear safety equipment as recommended by the chemical manufacturer before adding chemical to the sprayer 2. Check the suction line foot filter is clean and undamaged. 3.
Page 8
Maintenance Dispose of unused chemical and water used for rinsing in a manner that will not endanger people animals or the environment. After spraying rinse out the spray lines and tank with clean water: • Check the foot filter and clean if necessary, each time the tank is filled. To check the filter hook it out with a bent piece of wire.
Need help?
Do you have a question about the REDLINE SPOTPAK 25 and is the answer not in the manual?
Questions and answers