Tools Needed - Garmin GHP 20 Marine Autopilot System for Steer-by-Wire Installation Instructions Manual
Marine autopilot system steer-by-wire installation instructions
Hide thumbs
Also See for GHP 20 Marine Autopilot System for Steer-by-Wire:
- Owner's manual (28 pages) ,
- Product information (37 pages) ,
- Installation instructions manual (23 pages)
Table of Contents
Advertisement
NMEA 2000 drop cable, 6 ft. (2 m) (×2)
➊
NMEA 2000 power cable
➋
NMEA 2000 T-connector (×3)
➌
NMEA 2000 terminator, male
➍
NMEA 2000 terminator, female
➎
nMEa 2000 Extension Cables
NMEA 2000 extension cables are available if needed. Contact
your local Garmin dealer or Garmin Product Support for ordering
information.
tools needed
• Safety glasses
• Drill and drill bits
• 3
/
in. (90 mm) hole saw
1
2
• Wire cutters/strippers
• Phillips and flat screwdrivers
• Cable ties
• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a
heat gun
• Marine sealant
• Portable or handheld compass (to test for magnetic interference
when determining the best location to install the CCU)
• Anti-seize lubricant (optional)
NOTE: Mounting screws are provided for the GHC 10 and the CCU. If
the provided screws are not appropriate for the mounting surface, you
must provide the correct types of screws.
4
GHP 20 Installation Instructions
Hide quick links:
Advertisement
Table of Contents
