Nilfisk-Advance SC4000 Use And Maintenance

SC4000
ATTENTION! Do not use the machine before you have read and understood the User Manual
1. Check the battery charge
(and if necessary re-charge).
6. Install the brushes by removing
the side blades. The side blades
are removed by unscrewing the
fasteners.
1. Check the battery charge
11. Adjust water flow and detergent.
(and if necessary re-charge).
16. Untighten the yellow knobs, take
the squeegee off and remove
debris. Check and clean the
squeegee blades.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the
batteries (10-12 hours) will be required. Failure to carry out this this procedure may cause damage to the batteries. Charging the
batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY
BASIS
– Use and Maintenance
2. E-stop icon appears on display
when E-stop switch is engaged.
Twist E-stop switch until it pops
out to enable machine function.
7. Manually install disc brushes or
pad drivers. The brush comes in
from the left.
12. Empty the debris tray and clean/
wash the recovery tank inside.
17. Clean the filter:
A) Close the solution valve under the machine.
B) Remove the transparent cover and the gasket, then remove and
clean the solution water filter.
C) Reassemble the filter.
3. Fill the tank with clean water.
The clean water temperature
must not exceed 54 °C
(130F).
8 Lift the brush and rotate to the
left to lock into position. If click-
on option is available, align brush
directly below motor using align-
ment system and push brush
install button. (Disc version only).
13. Empty the recovery tank with
the squeezable hose.
The recovery lid should be left
open to dry.
4. Recovery tank seal cover must
be correctly installed and in
good condition to maintain good
suction performance at the
squeegee..
9. Remove side skirts and place
it on top of the black pins while
double scrubbing.
14. Slide out, check, empty and
clean the debris hopper
(cylindrical version).
18. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product.
5. Check the
not damag
squeegee
knobs. Che
squeegee
tor wheels
10. Press One
gage brush
15. Turn the br
wise and re
pad holder
or pads in
up to dry.
19. Charge the
when need