Nilfisk-Advance SC450 Use & Maintenance

Use & maintenance
- SC450
ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual
1a. Switch off charger by unplug 1b. Disconnect the battery charger
charger cable from red battery plug.
Reconnect the red battery plug to
the machine.
.
5. Place the brush or the pad-holder 6. Adjust (if needed) the brush deck
under the deck. Use the appropriate to have the correct machine
brush to clean the floor. directionality
10. At the end of the work. Empty 11. Wash with clean water the recovery
the recovery tank with the hose. Then
empty the solution tank with the
trasparent hose
15. Clean the filter by: Remove the 16. Clean the machine using a damp
transparent cover and the gasket
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk A/S Tel.: +45 43 23 40 50
Kornmarksvej 1 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk.com
Denmark www.nilfisk.com
All manuals and user guides at all-guides.com
2. Fill the tank with a clean water. The
cable from the electrical main. clean water temperature must not
exceed 40 °C.
7. Press the eco solution flow control
valve
12. Remove the brush/pad and clean
tank and the vacuum grid them
17. Charge the batteries: Connect the
cloth and where needed use a battery charger cable from the
electrical main
neutral cleaning product
3. If the squeegee is not connected to
4. If the squeegee is in upper position,
the machine: install and fasten it with
lower it with the lever
the handwheels, then connect to the
suction hose
8. Switch on the brush and vac motors 9. Press the handle switch to engage
the brush and run the machine
to activate the machine
13. Take the squeegee off and remove 14. Check and clean the squeegee
debris.
18. Park the machine with the recovery
tank cover open
blades