Configuring The Read-Only Replica On The Hub Supplier - Red Hat DIRECTORY SERVER 7.1 - ADMINISTRATOR Administrator's Manual

Configuring Cascading Replication
When you have configured the replicas on each server and the necessary
replication agreements among servers, you can initialize the read-only replicas on
the hub supplier and on the consumer. You can perform this task from the
Replication Agreement Wizard while you are configuring the supplier server and
the hub supplier server or at any time afterwards.
Configuring the Read-Only Replica on the Hub
Supplier
Perform these steps on the hub supplier that receives replication updates from the
supplier and propagates them to consumers:
Create the database for the replica if it does not exist.
1.
For instructions, refer to "Creating Suffixes," on page 80.
Create the entry corresponding to the supplier bind DN if it does not exist.
2.
NOTE
a.
b.
c.
d.
Specify the required replication settings.
3.
a.
b.
340 Red Hat Directory Server Administrator's Guide • May 2005
This is the special entry that the supplier will use to bind. The entry
must not be part of the replicated database.
In the Directory Server Console, select the Directory tab.
Create an entry.
For example you could use
Specify a
userPassword
If you have enabled the password expiration policy or intend to do so in
the future, disable it to prevent replication from failing due to expiration
of passwords.
To disable the password expiration policy on the
add the
passwordExpirationTime
, which means that the password will never expire.
20380119031407Z
In the Directory Server Console, select the Configuration tab.
In the navigation tree, expand the Replication node, and then select the
database to replicate.
The Replica Settings tab is displayed on the right pane.
cn=Replication Manager,cn=config
attribute-value pair.
attribute with a value of
.
attribute,
userPassword