Red Hat CLUSTER FOR ENTERPRISE LINUX 5.0 Configuration Manual page 56

Chapter 3. Configuring Red Hat Cluster With Conga
service must be started manually any time the cluster comes up from the stopped state.
Tip
Use a descriptive name that clearly distinguishes the service from other services
in the cluster.
4. Add a resource to the service; click Add a resource to this service. Clicking Add a
resource to this service causes the display of two drop-down boxes: Add a new local
resource and Use an existing global resource. Adding a new local resource adds a
resource that is available only to this service. The process of adding a local resource is the
same as adding a global resource described in
Adding a global resource adds a resource that has been previously added as a global
resource (refer to Section 8, "Adding Cluster
5. At the drop-down box of either Add a new local resource or Use an existing global
resource, select the resource to add and configure it according to the options presented.
(The options are the same as described in
Note
If you are adding a Samba-service resource, connect a Samba-service resource
directly to the service, not to a resource within a service.
6. If you want to add resources to that resource, click Add a child. Clicking Add a child causes
the display of additional options to local and global resources. You can continue adding
children resources to the resource to suit your requirements. To view children resources,
click the triangle icon to the left of Show Children.
7. When you have completed adding resources to the service, and have completed adding
children resources to resources, click Submit. Clicking Submit causes a progress page to be
displayed followed by a page displaying the added service (and other services).
Note
To verify the existence of the IP service resource used in a cluster service, you
must use the
output shows the
cluster service:
46
Section 8, "Adding Cluster
Resources").
Section 8, "Adding Cluster
/sbin/ip addr list
/sbin/ip addr list
Resources".)
command on a cluster node. The following
command executed on a node running a
Resources".