Creating A Shared Fence Device - Red Hat CLUSTER FOR ENTERPRISE LINUX 5.0 Configuration Manual

Hide thumbs Also See for CLUSTER FOR ENTERPRISE LINUX 5.0:

Table of Contents

Chapter 3. Configuring Red Hat Cluster With Conga

The starting point of each procedure is at the cluster-specific page that you navigate to from

Choose a cluster to administer displayed on the cluster tab.

5.1. Creating a Shared Fence Device

To create a shared fence device, follow these steps:

1. At the detailed menu for the cluster (below the clusters menu), click Shared Fence Devices.

Clicking Shared Fence Devices causes the display of the fence devices for a cluster and

causes the display of menu items for fence device configuration: Add a Fence Device and

Configure a Fence Device.

Note

If this is an initial cluster configuration, no fence devices have been created, and

therefore none are displayed.

2. Click Add a Fence Device. Clicking Add a Fence Device causes the Add a Sharable

Fence Device page to be displayed (refer to

Figure 3.1, "Fence Device

Configuration").

Table of Contents

Do you have a question about the CLUSTER FOR ENTERPRISE LINUX 5.0 and is the answer not in the manual?