Configuring Jobs By Editing The Configuration File; Configuration Parameters Of Requestinqueuenotifier - Red Hat CERTIFICATE SYSTEM 7.3 - ADMINISTRATION Administration Manual

Chapter 19. Automated Jobs
7. Click OK.
8. Click Refresh to view any changes in the main window.
9. If the job is configured to send automatic messages, check that a mail server is set up correctly.
Section 3.5, "Mail
See
10. Customize the email message text and appearance.

19.3.2. Configuring Jobs by Editing the Configuration File

1. Ensure that the Jobs Scheduler is enabled and configured; see
Scheduler".
2. Stop the CA subsystem instance.
/etc/init.d/rhpki-ca stop
3. Open the CS.cfg file for that server instance in a text editor.
4. Edit all of the configuration parameters for the job module being configured.
• To configure the requestInQueueNotifier job, edit all parameters that begin with
jobsScheduler.job.requestInQueueNotifier; see
Parameters of requestInQueueNotifier".
• To configure the publishCerts job, edit all parameters that begin with
jobsScheduler.job.publishCerts; see
publishCerts".
• To configure the unpublishExpiredCerts job, edit all parameters that begin with
jobsScheduler.job.unpublishExpiredCerts; see
Parameters of unpublishExpiredCerts".
5. Save the file.
6. Restart the server instance.
/etc/init.d/rhpki-ca start
7. If the job will send automated messages, check that the mail server is set up correctly. See
Section 3.5, "Mail Server".
8. Customize the automatic job messages.

19.3.3. Configuration Parameters of requestInQueueNotifier

Table 19.1, "requestInQueueNotifier Parameters"
be configured for the requestInQueueNotifier job, either in the CS.cfg file or in the Certificate
Manager Console.
444
Server".
Section 19.2, "Setting up the Job
Section 19.3.3, "Configuration
Section 19.3.4, "Configuration Parameters of
Section 19.3.5, "Configuration
gives details for each of these parameters that can