Configuring Jobs By Editing The Configuration File - Red Hat CERTIFICATE SYSTEM 8.0 - ADMINISTRATION Admin Manual

Chapter 11. Setting Automated Jobs
• For more information about setting the cron time frequencies, see
Settings for Automated
6. Click OK.
7. Click Refresh to view any changes in the main window.
8. If the job is configured to send automatic messages, check that a mail server is set up correctly.
Section 10.4, "Configuring a Mail Server for Certificate System
See
9. Customize the email message text and appearance.

11.3.2. Configuring Jobs by Editing the Configuration File

1. Ensure that the Jobs Scheduler is enabled and configured; see
Scheduler".
2. Stop the CA subsystem instance.
service pki-ca stop
3. Open the CS.cfg file for that server instance in a text editor.
4. Edit all of the configuration parameters for the job module being configured.
• To configure the certRenewalNotifier job, edit all parameters that begin with
jobsScheduler.job.certRenewalNotifier; see
Parameters of certRenewalNotifier".
• To configure the requestInQueueNotifier job, edit all parameters that begin with
jobsScheduler.job.requestInQueueNotifier; see
Parameters of requestInQueueNotifier".
• To configure the publishCerts job, edit all parameters that begin with
jobsScheduler.job.publishCerts; see
publishCerts".
• To configure the unpublishExpiredCerts job, edit all parameters that begin with
jobsScheduler.job.unpublishExpiredCerts; see
Parameters of unpublishExpiredCerts".
5. Save the file.
6. Restart the server instance.
service pki-ca start
7. If the job will send automated messages, check that the mail server is set up correctly. See
Section 10.4, "Configuring a Mail Server for Certificate System
8. Customize the automatic job messages.
264
Jobs".
Section 11.3.7, "Frequency
Notifications".
Section 11.2, "Setting up the Job
Section 11.3.3, "Configuration
Section 11.3.4, "Configuration
Section 11.3.5, "Configuration Parameters of
Section 11.3.6, "Configuration
Notifications".