Step 6: Load The Ht Server Into The Rack - AMX MAX-HT SERVERS Manual

Rack Mounting MAX Servers
Adapter Bar
FIG. 63 Align the holes on the Adapter Bar to the holes on the rails in the equipment rack
FIG. 64 shows the Adapter Bars properly mounted to the Rack-Rail assemblies and vertical mounting
rails in the equipment rack:
Front mounting rail on the
FIG. 64 Adapter Bars mounted to the equipment rack

Step 6: Load the HT Server Into the Rack

Once the Rail Assemblies have been installed into the equipment rack cabinet, the server can be mounted
on the rails and slid into the rack (FIG. 65):
1. Slide the Rails (Intermediate Sections) out to their fully extended position.
2. Carefully align the Chassis Sections (mounted on the HT server) with the extended Rails.
3. Slide the server onto the extended rails. Keep the server parallel to the floor when sliding the server
rails into the rails. Tilting the server up or down could result in damage to the Slide Rails.
70
Mounting Rail in equipment rack
Align the top hole on the Adapter Bar to the bottom hole
of the upper-adjacent RU in the equipment rack.
Align the center hole on the Adapter Bar to a center hole
in one of the RUs in the equipment rack.
Align the bottom hole on the Adapter Bar to the top hole
of the lower-adjacent RU in the equipment rack.
equipment rack
Rear mounting rail on the
equipment rack
MAX Servers: HT Home Theater and MMS Multimedia Servers