Table of Contents
Advertisement
M
N
AKING
ETWORK
Fiber Optic SFP Devices
An optional Gigabit SFP transceiver (1000BASE-SX, 1000BASE-LX, or
1000BASE-ZX) can be used for a backbone connection between switches,
or for connecting to a high-speed server.
Each single-mode fiber port requires 9/125 micron single-mode fiber
optic cable with an LC connector at both ends. Each multimode fiber optic
port requires 50/125 or 62.5/125 micron multimode fiber optic cabling
with an LC connector at both ends.
Warning:
Note: When selecting a fiber SFP device, considering safety, please make
sure that it can function at a temperature that is not less than the
recommended maximum operational temperature of the product.
You must also use an approved Laser Class 1 SFP transceiver.
1. Remove and keep the LC port's rubber plug. When not connected to a
fiber cable, the rubber plug should be replaced to protect the optics.
2. Check that the fiber terminators are clean. You can clean the cable
plugs by wiping them gently with a clean tissue or cotton ball
moistened with a little ethanol. Dirty fiber terminators on fiber optic
cables will impair the quality of the light transmitted through the cable
and lead to degraded performance on the port.
3. Connect one end of the cable to the LC port on the switch and the
other end to the LC port on the other device. Since LC connectors are
keyed, the cable can be attached in only one orientation.
4-4
C
ONNECTIONS
This switch uses lasers to transmit signals over fiber optic
cable. The lasers are compliant with the requirements of a
Class 1 Laser Product and are inherently eye safe in normal
operation. However, you should never look directly at a
transmit port when it is powered on.
Advertisement
Table of Contents
