Table of Contents
Advertisement
Section - Installation
Hardware Installation
Power
Plug the DXN-220 into an AC wall outlet or power strip.
Note: Power source is confirmed when the green LED Power indicator on the DXN-220 is illuminated.
Connect the Ethernet Cable
Connect the included Ethernet cable to the LAN port located on the DXN-220 and attach the other end of the Ethernet
cable to the network or PC.
Connect the Coaxial Cable
Connect a coaxial cable to the Coax I/O port located on DXN-220 and attached the other end of the coax cable to your
cable jack inside the house.
Note: Please make sure the DXN-220's configuration switch is in MoCA mode. Coaxial Network Connectivity is
confirmed when the green LED COAX indicator on the DXN-220 is illuminated.
If there is TV service being received in the room and you wish to continue viewing the service, connect the other
coax cable to the TV Out port on the DXN-220 and attach the other end of the coax cable to your television,
Set-top Box (STB), or VCR as desired.
Refer to the diagram on the next page.
D-Link DXN-0 User Manual
11
Hide quick links:
Advertisement
Table of Contents
