Related Manuals for Diplomat Premium DA370
Summarization of Contents
03. Prepare installation site
Fix unit to floor without base plate
Secure the dental unit to the floor using four drilled holes when a base plate is not used.
Fix unit to base plate with balancing
Mount the dental unit to the base plate, allowing for adjustable balancing without drilling.
10. Electrical connections
Basic and Full Config connection steps
Perform identical connection steps for both BASIC and FULL configurations by removing the electronics cover.
Basic configuration wiring (PB_LUX_8)
Connect the XENOS lamp to the PB_LUX_8 board for basic configuration.
Full configuration wiring (PB_LUX_11)
Connect the XENOS lamp and select suction mode for full configuration using PB_LUX_11.
13. Foot controller setup
13.1 Cable connected foot controller
Connect the cable-connected foot controller to the main unit.
13.2.1 Connecting Wi-Fi foot controller battery
Connect the battery to the Wi-Fi foot controller transmitter (UNO and NOK models).
13.2.2 Connecting Wi-Fi receiver
Connect the RF receiver to the socket and verify communication status.
14. Finalize installation and disinfection
14.1 Adjust installed elements and balance
Adjust installed elements, including balancing the tray table, and check unit functionality.
14.2 Disinfect new dental unit
Perform necessary disinfection of instruments and waterlines before the unit's first use.
15. Install specific and optional parts
15.1 Install side tray table
Procedure for installing the side tray table on DA270 units, considering display placement.
15.2 Prepare base plate for microscope
Prepare the base plate by leading cabling through the column for microscope integration.
Need help?
Do you have a question about the Premium DA370 and is the answer not in the manual?
Questions and answers