Peripheral Device Installation - TYAN TOMCAT IIIS D User Manual

3.14 Peripheral Device Installation

After all the jumpers on the mainboard have been set, then it can be mounted
into the case. Then proceed to install the display card and any other periph-
eral devices.
If a PCI-Bus interface card is to be installed in the system, any one of the
five PCI-Bus slots can support either a Master or a Slave device.
After installing the peripheral controllers, the user should check everything
again, and prepare to power-on the system.
S1563-001-01 www.tyan.com 21