Related Manuals for Toshiba MJ-6106
Summarization of Contents
General Description of Toshiba Hole Punch Unit
Main Components of Hole Punch Unit
Identifies the primary parts of the hole punch unit, including covers and scrap box.
Sectional View of Hole Punch Unit
Illustrates the internal layout and components of the unit with numbered parts.
Electric Parts Layout of Hole Punch Unit
Shows the physical placement of electrical components like motors and sensors.
Symbols and Functions of Components
Details the symbols used for motors, sensors, and PC boards and their functions.
Diagram of Signal Blocks
Visualizes the signal flow and connections between the finisher and the hole punch unit.
Description of Interface Signals
Explains the communication signals used between the finisher and the hole punch unit.
Description of Operations
General Operation of Hole Punch Unit
Provides an overview of how the hole punch unit functions with the finisher.
Punching Position Alignment Operation
Describes how the unit detects and adjusts for paper skew and sideways deviation.
Punching Operation Process
Explains the process of punching holes, including motor rotation and sensor timing.
Transport Operation Details
Details how the unit transports paper using the transport roller and motor.
Punched Scrap Detection
Describes how the unit monitors the punched scrap container status.
Disassembly and Assembly Procedures
Cover Removal and Installation
Instructions for removing and installing the front, rear, upper, and right covers.
Motor Disassembly and Assembly
Procedures for removing and installing skew, sideways, punch, and transport motors.
Punching Unit Removal
Steps for disassembling and removing the main punching unit.
Sensor and Switch Replacement
Guidelines for disassembling and replacing various sensors and switches.
PC Board Replacement
Steps for removing and installing the hole punch control PC board.
Roller Removal and Installation
Instructions for removing and installing the transport rollers and guides.
Adjustment Procedures
Stopping Position Adjustment
How to adjust the paper stopping position using self-diagnostic mode or DIP-SW.
Maintenance and Inspection
Maintenance and Inspection Points
Lists key maintenance tasks, lubrication, and inspection points.
Firmware Update Procedure
Guides for updating the unit's firmware using a download jig or USB device.
Electric Circuit Diagrams
Harness Diagram
Illustrates the wiring connections between the PC board and unit components.
Circuit Diagram Details
Detailed schematic diagrams of the unit's electrical circuits.
PC Board Layouts
Shows the layout and components of the hole punch control PC boards.
Need help?
Do you have a question about the MJ-6106 and is the answer not in the manual?
Questions and answers