Table of Contents
Advertisement
Press PgUp or PgDn to select a numbered hard disk type or type a
number and press <Enter>. Note that the specifications of your drive
must match the drive table. The hard disk will not work properly if you
enter improper information for this category. If your hard disk type is
not listed, you can select User to define your own drive manually.
If you select the User type, you will be asked to fill in the categories
shown in the chart below. Type in the parameters and press <Enter>.
Your hard disk information should be provided in the documentation
from the hard disk vendor or the system manufacturer.
CYLS
HEADS
PRECOMP
LANDZ
SECTOR
MODE
If a hard disk has not been installed or you have a CD-ROM or tape
drive connected to an IDE channel, select None and press <Enter>.
Drive A type/Drive B type
This category identifies the types of floppy disk drives that have been
installed in your computer as the A and/or B drives. The possible
floppy drive types are as follows:
None
No floppy drive installed.
360KB, 5.25 in.
5.25 inch PC-type standard drive; 360KB capacity.
1.2MB, 5.25 in.
5.25 inch AT-type high-density drive; 1.2MB capacity.
720KB, 3.5 in.
3.5 inch double-sided drive; 720KB capacity.
1.44MB, 3.5 in.
3.5 inch double-sided drive; 1.44MB capacity.
2.88MB, 3.5 in.
3.5 inch double-sided drive; 2.88MB capacity.
Floppy 3 Mode Support
Provides support for Floppy 3, a 1.25MB floppy type used mostly in
Japan.
number of cylinders
number of heads
write precomp cyl
landing zone
number of sectors
auto, normal, large, or LBA
29
Advertisement
Table of Contents
