Integrated Peripherals - TYAN TITAN TURBO AT-2 Manual

4.9 Integrated Peripherals

IDE HDD Block Mode :Enabled
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
USB Keyboard Support
On-Board FDC Controller
On-Board UART 1
On-Board UART 2 Mode
On-Board UART 2
The Settings in the Integrated Peripherals section allow you to enable or
disable on-board devices. You can also configure the I/O and IRQ
settings of the on-board serial and parallel ports.
s IDE HDD Block Mode
The terms "multiple commands," "multiple sector read/write," and
"block transfer" are all alternate names for block mode. Unless your
IDE hard drive is old, it should support block mode. If Enabled, yields
automatic detection of the optimal number of block read/writes per
sector that the drive can support.
s IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO
mode (0-4) for each of the four IDE devices supported by the onboard
IDE interface. Modes 0 through 4 provide successively increased
performance. In Auto mode, the system automatically determines the
best mode for each device.
s
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 can only be implemented if your IDE hard drive sup-
ports it and the operating environment includes a DMA driver. If
your hard drive and your system software both support Ultra
DMA/33, select Auto
S1571 D1181-001 http://www.tyan.com
Integrated Peripherals
Award Software, Inc.
On-Board Parallel Port
:Auto Parallel Port Mode
:Auto ECP Mode Use DMA
:Auto Parallel Port EPP Type
:Auto
:Auto
:Auto
:Auto
:Auto
:Enabled
:Enabled
:Disabled
:Enabled
:Com1/3F8
:Com2/2F8
:Standard
to enable BIOS support.
39
BIOS Configuration
: 378/IRQ7
: Normal
: 3
: EPP1.7