Table of Contents
Advertisement
Primary Display
Configures the type of monitor attached to the computer. The Optimal
and Fail-Safe default settings are VGA/EGA.
Above 1MB Memory Test
When this option is enabled, the system will test the entire memory pool
during the Power On Self Test(POST). If it is disabled, the system will
only count the amount of available memory without testing it.
Hit "DEL" Message Display
Enable or disable the "HitDELete key" message upon boot up.
The default is enabled.
Extended BIOS RAM Area
Specify in this option if the top 1 KB of the system programming area
begins at 639K (DOS 1K) or at address 0:300. In most instances 0:300
should be used. The default is 0:300.
W ait for "F1" if Any Error
Enable this option to display the message "Hit F1 to continue" when the
system encounters an error during POST. The default is Enabled.
System Boot Up Num Lock
This option lets you turn on or off the num lock for the keyboard during
boot up. The default is ON.
Floppy Drive Seek at Boot
This option enables or disables the floppy drive seek during POST.
The default is disabled.
Floppy Drive Swapping at Boot
When enabled, the system allows the floppy drives to swap drive letters
with each other. The default is disabled.
System Boot Up Sequence
This option determines which disk drive the system will attempt to boot
from first. The options are "A: to C:" or "C: to A:".
The default is "A: to C:"
S1461/6-001-01
49
Advertisement
Table of Contents
