TYAN THUNDER LE-T User Manual page 37

Boot up Num-Lock
Default: On
Boot up CPU Speed
Default: High
ATAPI Detect Time Out
Default: 35
PS/2 Mouse Support
Default: Enabled
Typematic Rate
Default: Fast
System Keyboard
Default: Present
Primary Display
Default: VGA
Parity Check
Default: Disabled
Boot to OS/2
Default: No
Wait for F1 if "error"
Default: Enabled
Hit "Del" Message
Default: Enabled
Internal Cache
Default: Write Back
3.2-E Onboard Device Configuration
Options related to onboard devices can be altered through the following.
Power Button 4
Seconds Off
Default: Enabled
Power Lost Control
Default: Always On
Onboard SCSI
Default: Enabled
Onboard 82559 (1)
Default: Enabled
Onboard 82559 (2)
Default: Enabled
Onboard Promise IDE
Controller
Default: Enabled
On
Off
High
Low
0, 5, 10, 15... 35
Enabled
Disabled
Fast
Slow
Present
Unavailable
VGA
BGA
Enabled
Disabled
Yes
No
Enabled
Disabled
Enabled
Disabled
Write Back
Page Flip
Enabled
Disabled
Previous State
Always Off
Always On
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
37
http://www.tyan.com
Specifies whether Num-
Lock will be on or off
during bootup.
Specifies the CPU speed
during startup.
Selects the amount of time
before ATAPI device
detection stops.
Toggles the use of the
PS/2 mouse port.
Changes speed of key
repeat rate.
Will allow continual boot if
the keyboard is not
attached.
Changes default video
mode. Leave as is.
Toggles checking of
system memory for
corruption.
Toggles boot to OS/2 OS.
Leave as default.
If Enabled, you will have to
press F1 for the system to
continue booting if an error
is detected during POST.
Toggles display of pressing
DEL key to enter BIOS.
Leave as default.
By default, you have to
hold the power button for 4
seconds in order to shut off
the system.
When set to Always On ,
the system will
automatically turn on.
Toggles the onboard SCSI
controller.
Toggles Network onboard
NIC 1.
Toggles Network onboard
NIC 2.
Toggles the use of the
onboard Promise
RAID/ATA-100 controller.