TYAN THUNDER LE-T User Manual page 27

There are two beveled corners on the CPU, which will match the tw o angled corners on the
socket. Careful install the CPU by lining both Pin 1 on the CPU and Pin 1 on the socket, making
sure the pins actually fit into the socket. Do not force the CPU into the socket: check the pin
alignment of the CPU pins to socket holes.
Push down lightly on the CPU while lowering the arm on the socket to secure the CPU (see right).
A squeaking noise may be heard while lowering the arm or the socket may make a 'click' noise
when the arm is locked into position: these noises are normal.
Installing the Cooling Fans
After a CPU has been installed, you will need to install the proper cooling device for the CPU. This
device, a heatsink/fan combination can be purchased at many computer retail stores. Installation
of the cooling device may vary depending on the fan manufacturer's design. You should also take
space into consideration when installing a cooling device: make sure the cooling device is not too
big, or else you may end up damaging components around the CPU socket.
Tyan highly recommends that you use a thin
layer of some type of thermal compound
(available from many computer retail stores),
between the CPU and the heatsink, to
maximize distribution of heat away from the
CPU. Please use extra caution when installing
any type of clamp-style fan, or else damage
may occur to the CPU socket and or the CPU
itself.
FAN
1 2
Ground +12V
The FAN connector has a 12V, 1.2A limitation. Tyan takes no responsibility and will
NOTE
not be held liable for damage related to the misuse of any FAN jumper.
Alternatively, if you wish to also install chassis fans for increased cooling, headers are provided to
power those fans as well. Chassis fan installation will vary depending on your chassis
manufacturer's design. Please check with your chassis manufacturer for details on proper chassis
fan installation.
3
Speed
http://www.tyan.com
Specifications
Voltage
Amperage
27
12V
1.2A