TYAN THUNDER K8HR Manual page 72

3.9.1.1 – Memory Configuration Sub-Menu
This menu has options for memory speed & latency. Use the up and down
arrow ( / ) keys to select an item. Use the Plus and Minus (+/-) keys to
change the value of the selected option.
Main Advanced
Memory Configuration
Memclock Mode
User Config Mode
Bank Interleaving
Burst Length
Enable Clock to All DIMMs
HardWare Memory Hole
Feature
Memory Configuration
Memclock Mode
MCT Timing Mode
User Config Mode
Burst Length
SoftWare Memory Hole
HardWare Memory Hole
CPU1 Mem DQ Driver
Strength
CPU2 Mem DQ Driver
Strength
BIOS Setup Utility
PCI/PnP Boot
[Auto]
[Auto]
[Auto]
[4 Beats]
[Disabled]
[Disabled]
Option
MEMCLK can be set by the code
Limit
using AUTO, or if you use LIMIT,
you can set one of the standard
Auto
values.
Manual Allows user to configure the MCT
Timing Mode manually.
Auto
Allows user to set the User Config
Manual
Mode manually.
Auto
Burst length can be set to 8 or 4
8 Beats
beats. 64 bit DQ must use 4 beats.
4 Beats
2 Beats
Allows user to enable software /
Disabled
hardware memory remapping
Enabled
around memory hole.
No Reduction This field controls the drive strength
reduction of the Memory DQ pins.
-15%
-30%
-50%
72
http://www.TYAN.com
Security Chipset
MEMCLK can be set
by the code using
AUTO, or if you use
LIMIT, you can set
one of the standard
values.
← → Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Description
Exit