TYAN THUNDER 2 ATX Manual page 36

Chapter 4
1st Boot Device
This option sets the type of device for the first boot drives that the
AMIBIOS attempts to boot from after AMIBIOS POST completes.
The settings are Disabled, Network, Floptical, SCSI, CDROM, IDE-0,
IDE-1, IDE-2, or IDE-3. The Optimal and Fail-Safe default settings are
IDE-0.
2nd Boot Device
This option sets the type of device for the second boot drives that the
AMIBIOS attempts to boot from after AMIBIOS POST completes.
The settings are Disabled, Floppy, Floptical, CDROM, or IDE-0. The
Optimal and Fail-Safe default settings are Floppy.
3rd Boot Device
This option sets the type of device for the third boot drives that the
AMIBIOS attempts to boot from after AMIBIOS POST completes.
The settings are Disabled, Floptical, Floppy, CDROM, or IDE-0. The
Optimal and Fail-Safe default settings are CD-ROM.
Try Other Boot Devices
Set this option to Yes to instruct AMIBIOS to attempt to boot from any
other drive in the system if it cannot find a boot drive among the drives
specified in the 1st Boot Device, 2nd Boot Device, and 3rd Boot
Device options. The settings are Yes or No. The Optimal and Fail-Safe
default settings are Yes.
Initial Display Mode
This option specifies the initial display mode when the system boots.
The settings are as follows:
Setting
BIOS The messages that AMIBIOS displays before booting the system will appear on the system monitor.
Silent The messages that AMIBIOS displays will not appear on the system monitor.
Description
36