TYAN THUNDER 2 ATX Manual page 51

Suspend Timeout
This option specifies the length of a period of system inactivity while
in Standby state. When this length of time expires, the computer enters
Suspend power state. The settings are Disabled, 4 msec, 8 msec, 12
msec, 16 msec, up to 508 msec, in increments of 4 msec. The Optimal
and Fail-Safe default settings are Disabled.
Slow Clock Ratio
This option specifies the speed at which the system clock runs in the
Standby Mode power saving state. The settings are expressed as a
percentage between the normal CPU clock speed and the CPU clock
speed when the computer is in the power-conserving state. The settings
are 0-12.5%, 12.5-25%, 25-37.5%, 37.5-50%, 50-62.5%, 62.5-75%, or
75-87.5%. The Optimal and Fail-Safe default settings are 50-62.5%.
Display Activity
When set to Monitor, this option enables event monitoring on the video
display. If set to Monitor and the computer is in a power saving state,
AMIBIOS watches for display activity. The computer enters the Full
On state if any activity occurs. AMIBIOS reloads the Standby and
Suspend timeout timers if display activity occurs. The settings are
Monitor or Ignore. The Optimal and Fail-Safe default settings are
Ignore.
Device 6 (Serial Port 1), Device 7 (Serial Port 2), Device 8 (Parallel
Port), Device 5 (Floppy Disk), Device 0 (Primary Master IDE),
Device 1 (Primary Salve IDE), Device 2 (Secondary Master IDE),
and Device 3 (Secondary Slave IDE)
When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the
computer is in a power saving state, AMIBIOS watches for activity on
the specified IRQ line. The computer enters the Full On state if any
activity occurs. AMIBIOS reloads the Standby and Suspend timeout
timers if activity occurs on the specified IRQ line. The settings for
each of these options are Monitor or Ignore. The Optimal and Fail-Safe
default settings are Ignore.
51