TYAN TEMPEST I5000PX Manual page 35

3.2.1 IDE Primary/Secondary Master/Slave Setup
Computer detects IDE drive type from drive C to drive F.
Press Enter on any of the Primary/Master, Primary/Slave, Secondary/Master,
Secondary/Slave options to view advanced details of the corresponding drive.
The system displays advanced details like the number of
heads/cylinders/sectors on the detected disk and the maximum storage
capacity of the disk.
Main Advanced
Type:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
↑↓
F1 Help Select Item
← →
Esc Exit Select Menu
The system displays advanced details like the number of
heads/cylinders/sectors on the detected disk and the maximum storage
capacity of the disk.
This option lets you set the following hard disk parameters:
Type
Selects the type of device connected to the system.
Auto / CD/DVD / Not Installed / ARMD
Multi-Sector Transfers
This option allows you to specify the number of sectors per block for multiple
sector transfers.
16 Sectors / 2 Sectors / 4 Sectors / 8 Sectors /Disabled
LBA Mode Control
Enables or disables LBA Mode.
When LBA is turned on, the BIOS will enable geometry translation. This
translation may be done in the same way that it is done in Extended CHS or
PhoenixBIOS Setup Utility
Security Power
[Auto]
[Disabled]
[Disabled]
[Disabled]
[Standard]
[Disabled]
-/+ Change Values
Enter Select
Sub-Menu
35
Boot Exit
Item Specific Help
User = your enter
parameters of hard-disk
drive installed at this
connection.
Auto = autotypes hard-
disk drive installed here.
1-39 = you select pre-
determined type of
hard-disk drive installed
here.
CD-ROM = a CD-ROM
drive is installed here.
ATAPI Removable =
removable disk drive is
installed here.
F9 Setup Defaults
F10 Previous Values