Table of Contents
Advertisement
a -
928
Steering
48
1. Remove knee protector strip. The fastening
screws and nuts (arrows) are accessible
after removal of the center console cover
and of the air outlet nozzle.
Note
If the steering wheel height adjuster is
modified to the new version, assembly may
be started from item 2 immediately
after
removal of the knee protector strip (e.g. if the
adjuster lever/through
bolt union is discon-
nected). This means that adjuster mechanism
items No. 10 to 18 (page 48
34) do not
have to be dismantled
any further.
2. Turn adjuster lever of height adjuster to the
open position. For dismantling
sequence,
refer to explosion
drawing on page 48 - 34.
Assembly
1. If required, fit parts No. 10 to No. 18
(p. 48
34).
2. For further assembly or fitting, use only the
parts applicable
as of MY '92 (modified ver-
sion with spring clip).
For identification
of the relevant parts, refer
to page 48
40.
3. Undo lock nut (No. to). Open setting nut
(No. 12) by a minimum amount. If parts
- No. 10 to No. 18
had not been
removed, mark previous position of the
setting nut (No. 12).
1
a
Dismantling
and assembling
instructions
48 - 37
Printed in Germany - XXVII, 1991
Hide quick links:
Advertisement
Table of Contents
