Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 173

45
Antiblock System
928
6. Unscrew cable release and
take
off 12.pin
plug (no. 3).
Note:
Both relays for pump motor (2) or solenoid
valves (1) can be replaced (see page 45 - 6).
\:.
I-
I <
w
sres
Note:
Never loosen or tighten bolts marked with
arrows.
7. Disconnect ground wire on pump motor and
loosen two mounting bolts.
8. Loosen mounting bolt as well as bracket
for hydraulic unit.
Run out hydraulic unit (see installation
points 1 + 2).
45 - 2
Removing and Installing Hydraulic Unit
0
Printed in Germany