Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 205

46
Brakes/Mechanical
928
REMOVING AND INSTALLING BRAKE PEDAL
Removing
1. Move back seat and steering wheel up to make job
easier.
If applicable, remove shelf.
2. Disconnect return spring on brake pedal. Remove
shaft for brake and clutch push rod.
-7L J,,
,.
4pq J?y
1
3. The guide rod for clutch power spring has an
assembly bore. Press down on clutch pedal until
bore has cleared the bearing. Insert a piece of
3 mm dia. wire into bore in this position to
remove force on pedal.
4. Remove circlip and move bearing shaft toward
outride until brake pedal has been run out.
1 1
YF-7~~ 1 YF-7~~ 1
':y,, : I_ y r, i',_i '. I:"' ;;,-; ':y,, : I_ y r, i',_i '. I:"' ;;,-;
7. 7.
'\ *' '\ *'
; ),C,. ' ; ),C,. '
\ ! ~ '.y:*:>!. \ ! ~ '.y:*:>!.
i' I$" i' I$"
., , ( ., , (
?' ?'
-;':\ .,, .;;,': $1 ;, -;':\ .,, .;;,': $1 ;,
i i
., :: ., ::
,I,;: yj." ,I,;: yj."
w4, " w4, "
Installing
1. Check all bushings and stops for clutch and brake
pedals, replace if necessary. Lubricate all bearing
and sliding surfaces wth a multi.purpose grease.
2. Install brake pedal with bushings. Slide in bearing
shaft and install circlip.
Note:
Bearing shaft can only be pushed in fully, if bearing
shaft and console surfaces are aligned.
3. Remove wire in guide rod for clutch power
spring.
4. Install clutch and brake push rod.
Attach return spring. Check push rod play.
correcting if necessary.
Clutch play. see page 30. 1 (approx. 3 mm on
pedal equals approx. 0.5 mm between push rod
and master cylinder pistonl.
If there is a mechanical stop light switch. check
the adjustment.
46 B Removing and Installing Brake Pedal
a
VIII, 1984
Printed in Germany