Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 297

48
Steering
928
a
DISASSEMBLING AND ASSEMBLING STEERING WHEEL HEIGHT CONTROL
Disassembling
Assembling
1. Move steering wheel height control lever to release
position.
Remove balls and spring. Make sure that a cloth is
held above the area of the balls (to prevent injury)
and catch the first ball after turning the bracket.
2. Unscrew self-locking hexagon nut. Move out
control lever with stud and take off bracket.
'. v yytiill~
T
.
1. Screw stud in control lever. Threaded part must
protrude slightly (arrow).
2. Mount bracket on steering tube. Give sliding
surfaces a thin coat of Optimoly HT paste. Insert
control lever with stud and screw in mounting nut
Only screw in mounting nut finger tight.
3. Install balls and springs. First install one ball with
spring. Then apply second ball with spring, using a
suitable piece of pipe or a socket wrench, until the
bracket can be turned on the balls. Balls must
engage in one of the 5 holes in the bracket.
48 .28 Repairing Steering and Intermediate Shafts
with Steering Tube
Printed in Germany