Renesas RZ/A1M Manuallines

RZ/A1
Guidelines for High-Speed USB2.0 Board Design
Introduction
This application note details guidelines for the design of High-Speed USB2.0 circuit boards.
Target LSIs
The following groups in the RZ/A Series
RZ/A1H* * group, RZ/A1M*
1, 2
RZ/A1L* * group, RZ/A1LU*
1, 3
Notes: The contents in this application note are reference examples based on the USB standard, and signal
quality in the system is not guaranteed. When incorporated into an actual system, sufficient
verification and evaluation of the system overall should be performed, and determination of
applicability is the customer's responsibility.
"Group" will be omitted in the rest of this application note.
*1. In this application note, when indicating these groups collectively, it will be noted as "RZ/A1".
*2. In this application note, when indicating these groups collectively, it will be noted as "RZ/A1HM".
*3. In this application note, when indicating these groups collectively, it will be noted as "RZ/A1L".
Reference Application Notes
For additional information associated with this document, refer to the following application notes.
• RZ/A Series Hardware Design Guide (R01AN4813EJ)
R01AN5119EJ0120 Rev.1.20
May.26.20
* group
1, 2
* group, RZ/A1LC*
1, 3 1,
* group
3
Application Note
Page 1 of 17