Table of Contents
Advertisement
OPERATING FIREPLACE
Continued
Note: You may be running this heater for
the first time after connecting to gas supply
or at the start of your heating season. If so,
the ON button may need to be pressed again.
This will allow air to bleed from gas system.
If several attempts to light pilot fail, contact
a qualified service person or gas supplier
for repairs. Until repairs are made, light
and operate manually (see Manual Lighting
Instructions for Electrical Power Outage).
4. When pilot flame is lit, the thermocouple is
heated by the flame. When thermocouple
becomes hot (5 to 15 seconds), main burner
will automatically light on high flame.
5. To lower flame, point remote control
toward lower front of fireplace and push
HI/LO button once.
Note: This fireplace does not have a pilot-
only mode.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater - Wall Switch
Push ON/OFF button on wall switch once.
Shutting Off Heater - Wireless Remote
Control
Point remote control toward lower front of fire-
place and push both buttons at the same time.
MANUAL LIGHTING
INSTRUCTIONS FOR
ELECTRICAL
POWER OUTAGE
WARNING: You must oper-
ate this heater with the fireplace
screen in place. Make sure fire-
place screen is in place before
running heater.
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Open damper or window to vent
smell. This will only last a few
hours.
113134-01B
HI/LO
Button
LED
www.desatech.com
Piezo Ignitor
Wall
Switch
23
Advertisement
Table of Contents
