INSTALLATION
Continued
11. Using a keyhole saw, hack saw blade, drill,
file, or other suitable tool, carefully cut out the
rectangular opening. Note: The corners of the
rectangle may be round. IMPORTANT: Do not
exceed the size of the rectangle on template.
12. From inside the recessed opening for the
fireplace, carefully pass wall switch assembly
through the rectangular opening to the outside
of the wall.
13. Using wall anchors supplied in hardware pack-
age, fold wall anchor as shown in Figure 11.
14. Insert wall anchor, wings first, into hole. Tap
anchor flush to wall.
15. For thin walls (1/2" or less), insert red key into
wall anchor. Push red key to "pop" open anchor
wings. See Figure 12. IMPORTANT: Do not
hammer key! For thick walls (over 1/2" thick),
do not pop open wings.
16. Position wall switch assembly vertically over
wall openings with decal lettering upright (see
Figure 13).
Figure 11 - Folding Anchor
Figure 12 - Popping Open Anchor Wings
for Thin Walls
Figure 13 - Securing Wall Switch
Assembly
12
Opening
in Wall or
Mantel Wall
Wall Switch
Assembly
Screws
www.desatech.com
113134-01B