Gemini GEM-RP3DGTL Operating Manual page 25

6. Continuing, set the cursor to the
user code with the button and enter
A
the new User Code using the number but-
tons. Press for any blank loca-
G0
tions until you end up back to the flashing
"UP".
J
7. Press the button to save the code
in memory.
Repeat Steps 4 through 7 for each
user.
Note: To void a code, simply enter the
2-digit user number, then press the
ton.
Programming Example
Example. Program User 3's Code as
"3784".
1. Select the Program Mode as follows:
(a) Enter your code, then press the
A button.
(b) Answer NO ( button) repeatedly until "17" is displayed, then press the YES (
F
followed by 4 digits (for installer's use), then "UP" (indicating user programming) and the lights will continue to flash.
2. Press the button then
A
3784 G0 G0
GEM-RP3DGTL.pub
page 25
P R O G R A M M I N G ( O P T I O N A L )
To Program User Codes
1. Enter program code, then press
A
the button.
F
2. Press NO ( ) until "17"
displays, then press YES
E
( ).
3. When "UP" displays with a
flashing light, use the number
buttons to enter a 2-digit user
number followed by a user code
of up to 6 digits.
J
4. Press the button to save.
J
5. Repeat steps 3 & 4 to enter all
but-
user codes.
C
6. Press the button to exit.
NOTE: Press G 0
To continue press
to enter User No. 3, then press the
03
to program the code.
button to clear character at cursor.
E F
or button.
Programming User Codes
button). The display will scroll "P"
E
button again followed by
A
25
Wednesday, August 18, 1999 14:03