Fire Protection - Gemini GEM-RP3DGTL Operating Manual

(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
08
INTERIOR BYPASS FIRE/TBL SYS TBL
08
BYPASS FIRE/TBL SYS TBL
INTERIOR
12
GEM-RP3DGTL.pub
page 12
F I R E P R O T E C T I O N
Fire-Zone Alarm
If a fire is detected, the "FIRE TBL" light will display with the zone number and the
CHIME
keypad sounder will pulse.
1. If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
2. If there is no evidence of a fire, enter your code and press the
off the alarm.
3. Check smoke detector(s). If a smoke detector tripped, its red alarm indicator
light will be on.
4. Press the button to silence the keypad sounder.
C
5. After the alarm condition is corrected (thermostat cooled down; smoke cleared
from detector; etc.), pressing the
about 10 seconds.
Fire-Zone Trouble
1. If a problem on a fire zone is detected, the zone number will display along with
the "FIRE TBL" (fire trouble) light, a flashing "SYS TBL" light and the sounder will
CHIME
pulse to signal a malfunction.
2. Press the button to silence the sounder. Call for service immediately!
C
J
button again will reset the keypad within
C
Wednesday, August 18, 1999 14:03
button to turn