Pfaff SMART 200C Owner's Manual page 47

5. Position the fabric so that the needle is
2mm (1/16 inch) in front of the area to
be darned. Pass the upper thread down
through the hole in the presser foot and
then lower the presser foot lever.
Please Note: When lowering the
presser foot, do not push in the front of
the presser foot, otherwise the darning
will not be sewn with the correct size.
6. Pull down the buttonhole lever then push
it back. The buttonhole lever is positioned
behind the bracket on the buttonhole foot.
Gently hold the end of the upper thread in
your left hand, and then start sewing.
Please Note: When you select any
buttonhole pattern or darning pattern,
the LCD screen will display the fi gure
, to remind you to pull down the
buttonhole lever.
7. Darning stitches are sewn from the front of
the presser foot to the back, as shown.
8. If the area to be darned is too big to sew
with one darning stitch, you can sew
several times (or cross sew) to get better
sewing result.
47