Troubleshooting; Declaration Of Conformity - STEINEL PRESENCE CONTROL PRO Manual

Troubleshooting

Malfunction Cause
í No supply voltage
Light does not switch 'ON'
í Lux setting too low
í No motion detection
í Lux setting too high
Light does not switch 'OFF'
í Stay-'ON' time running out
í Interference from sources of
heat, e.g.: fan heater, open
doors and windows, pets,
light bulb/halogen floodlight,
moving objects
í Stay-'ON' time too short
Sensor switches 'OFF' in spite of
í Light-level threshold too low
persons being present
í Stay-'ON' time too long
Sensor does not switch 'OFF'
quickly enough
í Reach is reduced when ap-
Sensor does not switch 'ON'
quickly enough when approached
proached from the front
from the front
í Lux setting too low
Sensor does not switch 'ON'
when persons are present in
spite of it being dark
Remedy
í Check supply voltage
í Slowly increase lux setting
until light switches 'ON'
í Ensure unobstructed sensor
vision
í Check detection zone
í Reduce lux setting
í Wait until stay-'ON' time
elapses; reduce stay-'ON'
time if necessary
í Use stickers to mask
out stationary sources
of interference
í Increase stay-'ON' time
í Change light threshold
í Reduce stay-'ON' time
í Install additional sensors
í Reduce distance between
two sensors
í Sensor deactivated by
switch/button?
í Semi-automatic mode?
í Increase light-level threshold
- 28 -

Declaration of Conformity

This product complies with Low EMC Directive 2004/108/EC and
Voltage Directive 2006/95/EC, RoHS Directive 2002/95/EC.
Functional Warranty
This Steinel product has been The warranty period is 36 months
manufactured with utmost care, and starts on the date of sale to
tested for proper operation and the consumer. We will remedy
safety and then subjected to ran- defects caused by material flaws
dom sample inspection. Steinel or manufacturing faults. The war-
guarantees that it is in perfect ranty will be met by repair or re-
condition and proper working placement of the defective parts
order. at our own discretion. The war-
ranty shall not cover damage to
wear parts, damage or defects
caused by improper treatment or
maintenance. Further conse-
quential damage to other objects
is excluded.
Claims under the warranty will
only be accepted if the product
is sent fully assembled and well
packed complete with a brief
description of the fault as well
as a receipt or invoice (date of
purchase and dealer's stamp) to
the appropriate Service Centre.
Repair service:
Our Customer Service Depart-
ment will repair faults not cov-
ered by warranty or after the
warranty period. Please send
the product well packed to
your nearest Service Centre.
- 29 -