Configuration Manager Messages - Dell Precision 400 User Manual

C
onfiguration Manager
Messages
The Configuration Manager for the ICU identifies prob-
lems following system boot and generates messages if
necessary. These messages alert you to any unsuccessful
Message
Found Plug and Play
ISA card: Plug and Play
ISA Card Name .
NOTICE: Boot Device
Not Active! CSN= Card
Select Number .
One or more active
devices have been
reconfigured -- system
requires reboot. Press
any key to reboot
system.
The Plug and Play ISA
card has been success-
fully configured.
Card Count Plug and
Play ISA cards have
been successfully
configured.
ERROR: Insufficient CM
Memory
ERROR: Fatal BIOS
error Internal Error
Code .
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
C-6 Dell Workstation Midsize Systems User's Guide
Table C-2. Configuration Manager Messages
Probable Cause
This message appears at sys-
tem start-up for each Plug
and Play ISA expansion
card recognized by the Con-
figuration Manager.
A boot device was found to
be inactive.
You modified the resource
values of one or more PCI or
Plug and Play ISA expan-
sion cards.
The Configuration Manager
has successfully configured
the given number of cards.
There is not enough memory
available to the Configura-
tion Manager for it to run.
A BIOS call failed with an
internal error. The most
likely cause is an incompati-
bility between the BIOS and
the Configuration Manager.
attempts to configure Plug and Play or Peripheral Com-
ponent Interconnect (PCI) expansion cards, as well as
any problems that interfere with the operation of the Con-
figuration Manager. If you receive a message from the
Configuration Manager, see Table C-2 for suggestions on
resolving any problems indicated by the message.
Corrective Action
Status message; no action is required.
Status message; no action is required. The Config-
uration Manager automatically configures and
activates the device.
Reboot the system to reconfigure the card(s).
If this message does not match the number of Plug
and Play ISA expansion cards installed in your
computer, reinstall any Plug and Play expansion
cards not listed and reboot the system.
Disable any TSR programs or any unneeded
device drivers.
See the chapter titled "Getting Help" in your
Diagnostics and Troubleshooting Guide for
instructions on obtaining technical assistance.