Video Off Method; Modem Use Irq; Ac Loss Auto Restart - Biostar P4M890-M7 FE - BIOS SETUP Manual

P4M900-M7 FE/P4M890-M7 FE

Video Off Method

This option determines the manner when the monitor goes blank.
V/H SYNC+Blank
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.

Modem Use IRQ

This determines the IRQ, which can be applied in MODEM use.
The Choices: 3 (default), 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWRBTN
This item determines the behavior of system power button. Instant off turn off
the power immediately, and Delay 4 Sec. will require you to press and hold the
power button for 4 seconds to cut off the system power.
The Choices: Delay 4 Sec, Instant-Off (default).

Ac Loss Auto Restart

This setting specifies how your system should behave after a power fail or
interrupts occurs. By choosing off will leave the computer in the power off state.
Choosing On will reboot the computer. Former-Sts will restore the system to the
status before power failure or interrupt occurs.
The Choices: Off (default), On, Former-Sts.
HPET Support
This option allows you to disabled or enables the High Precision Event Timer.
The Choices: Enabled (default), Disabled.
HPET Mode
This option allows you to select the modes of the High Precision Event Timer.
The Choices: 32-bit mode (default), 64-bit mode.
WDRT Support
This option allows you to disabled or enables the Watchdog Timer.
The Choices: Enabled (default), Disabled.
(default)
28