Desa CDCFNRA Owner's Operation And Installation Manual page 20

INSTALLATION
Continued
4. Gently remove the cover of the thermostat
from the base. Grasp the sides of the cover
firmly and pull to separate from the base.
5. Feed the electrical wires through the rectangular
slots on each side of the base (see Figure 31).
WARNING: Do not con-
nect the thermostat to a power
source. Electrical shock and/or
a fire hazard will occur.
6. Connect one bare wire end to each terminal
("W" and "R") of the thermostat base (see
Figure 32).
7. Install the base onto the wall with the provided
screws.
8. Move the temperature adjustment back and forth
to insure the bimetal is free from restrictions.
9. Replace the cover onto the base. (Upon in-
stallation, the thermostat must be allowed to
stabilize at room temperature for a minimum
of 30 minutes for proper operation).
10. Set the temperature adjustment to the desired
setting. This thermostat has been electroni-
cally calibrated at the factory. No adjustment
or leveling is necessary.
Feed wires through
rectangular slots
Figure 31 - Back View of Thermostat Base
20
Figure 32 - Thermostat Base Terminals
www.desatech.com
Terminal "W"
Terminal "R"
"W" and "R"
W
R
116658-01A