Restoring Several Partitions At Once; Setting Restore Options; Restoration Summary And Executing Restoration - ACRONIS TRUE IMAGE 9.1 - FOR LINUX User Manual

2. Click Next.
6.3.9

Restoring several partitions at once

1. During a single session, you can restore several partitions or disks, one by one, by
selecting one disk and setting its parameters first and then repeating these actions for every
partition or disk to be restored.
If you want to restore another disk (partition), select Yes, I want to restore another
partition or hard disk drive. Then you will return to the partition selection window (6.3.4)
again and will have to repeat the above steps. Otherwise, don't set this switch.
2. Click Next.
6.3.10

Setting restore options

1. Select the options for restoration process (that is, pre/post restoration commands,
restoration process priority etc.). You may Use default options or Set the options
manually. If the latter is the case, the settings will be applied only to the current restore
task. Alternatively, you can edit the default options from the current screen. Then your
settings will be saved as default. See
2. Click Next.
6.3.11

Restoration summary and executing restoration

1. At the final step, the restoration summary is displayed. Up to this point, you can click
Back to make changes in the created task. If you click Cancel, no changes will be made to
disk(s). Clicking Proceed will launch the task execution.
2. The task will appear on the Active tasks pane of the main window. The task progress
will be shown in the special window.
Copyright © Acronis, Inc., 2000-2007
Restoring the backup data under X Window System
6.5 Setting restore options
for more information.
45