Troubleshooting A Damaged Array - Dell PowerVault MD3200i Owner's Manual

• Hard drives
• RAID controller modules
• Power supply/cooling fan modules
• Control panel
• Backplane
3 Let the system dry thoroughly for at least 24 hours.
4 Reinstall the components you removed in step 2.
5 Connect all the cables and turn on the array.
If the array does not start properly, see "Getting Help" on page 259.

Troubleshooting a Damaged Array

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Ensure that the following components are properly installed:
• Hard drives
• RAID controller module s
• Power supply/cooling fan modules
• Control panel
• Backplane
2 Ensure that all the cables are properly connected and that there are no
damaged pins in the connectors.
3 Run diagnostics available in Dell™ PowerVault™ Modular Disk (MD)
Storage Manager software. In the AMW, select a component in the
Physical pane of the Physical tab. Select Advanced Troubleshooting
Run Diagnostics.
If the test fails, see "Getting Help" on page 259.
256
Troubleshooting: Your Array
Many repairs may only be done by a certified service technician.