Dell PowerVault MD3200i Owner's Manual page 252

Reseat the EMM module and wait for 30 seconds. See Removing an
c
EMM in the MD1200 and MD1220 Storage Enclosures Hardware
Owner's Manual.
Turn on the server.
d
Check the EMM status LED.
e
If the LED does not turn Green, replace the EMM.
f
If the problem is not resolved, see "Getting Help" on page 259.
• If EMM status LED is blinking amber (5 times per sequence), update the
firmware to the latest supported firmware on both the EMMs. For more
information about downloading the latest firmware, see "Management:
Firmware Downloads" on page 187.
• If the link status LEDs are not green:
Turn off the server.
a
Reseat the cables on the expansion enclosure and the server.
b
Turn on the expansion enclosures and then the storage array and wait
c
until the system is fully booted.
Turn on the server.
d
Check the link status LED. If the link status LED is not green, replace
e
the cables.
If the problem is not resolved, see "Getting Help" on page 259.
252
Troubleshooting: Your Array