Configuring Alert Notifications; Configuring E-Mail Alerts - Dell PowerVault MD3200i Owner's Manual

3 Click OK.
4 If you have set a password for the selected storage array, the Enter
Password dialog appears. Type the current password for the storage array.
5 Click OK.

Configuring Alert Notifications

MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1 In the EMW, select the Setup tab.
2 Select Configure Alerts.
The Configure Alerts dialog is displayed.
3 Select All storage arrays.
4 Click OK.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 74. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 77.
To configure alert notifications for a single storage array:
1 In the EMW, select the Devices tab.
2 Select the relevant storage array, then select EditConfigure Alerts.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 74. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 77.

Configuring E-mail Alerts

For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 74.
To configure e-mail alerts:
1 Open the Configure Alerts dialog by performing one of these actions:
74
Configuration: About Your Storage Array