Configuring Snmp Alerts - Dell PowerVault MD3200i Owner's Manual

• You must use fully qualified e-mail addresses, for example,
name@mycompany.com.
You can configure multiple e-mail addresses before you click OK.
•

Configuring SNMP Alerts

To add a management console to the list of addresses configured to receive
SNMP alerts:
1 Open the Configure Alerts dialog by performing one of these actions:
• In the Tree view or the Table view on the Devices tab in the EMW,
select a node, and select Edit Configure Alerts. Go to step 3.
• In the Setup tab in the EMW, select Configure Alerts. Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
• All storage arrays—Select this option to send an alert notification
about events on all storage arrays.
• An individual storage array—Select this option to send an alert
notification about events that occur in only a specified storage array.
These results occur, depending on your selection:
• If you selected All storage arrays, the Configure Alerts dialog appears.
• If you selected An individual storage array, the Select Storage Array
dialog appears. Select the storage array for which you want to receive
alert notifications and click OK. The Configure Alerts dialog appears.
NOTE:
the LEDs of the storage array.
3 Select the SNMP tab to configure the SNMP alert destinations.
Adding an SNMP address—In Community name, type the
•
community name. In Trap destination, type the trap destination, and
click Add.
NOTE:
Interchange (ASCII) string that identifies a known set of network management
stations and is set by the network administrator. The default community name
is the string "public". The trap destination is the IP address or the host name
of a computer running an SNMP management application. An example of a
SNMP enabled management application is the Dell Management Console.
Please see dell.com for more information on the Dell Management Console.
If you do not know which storage array to select, click Blink to turn on
The community name is an American Standard Code for Information
Configuration: About Your Storage Array
77