Resuming Operation - Fujitsu ST6012 - Stylistic Tablet PC User Manual

• The suspend action of the Suspend/Resume switch may be disabled to prevent accidental
interruption. If this is the case, sliding the Suspend/Resume switch will not suspend system
operation as described here. (In this case, sleep mode can only be achieved using the system
software). Contact your local help desk or reseller if your system configuration is not suitable.
• If your system is equipped with a PC Card that allows you to connect to a wired or wireless network,
you may be logged off the network after a period of inactivity while system operation is suspended.
Contact a network administrator or help desk, or call Fujitsu Service and Support at 1-800-8Fujitsu
(1-800-838-5487) for details on your network log-off parameters.

Resuming Operation

To resume operation from either Sleep or Hibernate modes, slide the Suspend/Resume switch.
• From Sleep mode
Status lights indicate that the system state is changing. It may take up to a minute before the system
returns to the On state and system operation resumes. Note that the display turns on shortly before
the pen becomes active due to the power-up sequences observed by the system.
• From Hibernate mode
Active data is read from the hard disk drive, and the system returns to the On state after a short time
N
OTE THAT POWER TO SEVERAL SYSTEM COMPONENTS MUST BE RESTORED BEFORE SYSTEM
OPERATION RESUMES
ATTEMPTING TO USE THE SYSTEM
RESUME OPERATION AS COMPARED TO USING
HARD DISK DRIVE
Use the system as you normally would once system operation resumes.
All programs resume at the point where execution stopped when system operation was suspended.
. A
LLOW SUFFICIENT TIME FOR SYSTEM OPERATION TO RESUME BEFORE
. I
F YOUR SYSTEM USES
.
53 - Starting the Tablet PC
H
IBERNATE MODE
S . T
LEEP MODE IME IS NEEDED TO READ DATA FROM THE
,
IT WILL TAKE LONGER TO
.