Fujitsu ST6012 - Stylistic Tablet PC User Manual page 51

To suspend system operation:
1
Slide the Suspend/Resume switch, or carry out the Sleep command from your operating system or power
management program. (If your system is configured to suspend operation using Hibernate mode, which is
explained later in this procedure, a message is displayed while data is saved to your hard disk.)
2
The Power icon either flashes (Sleep) or is not displayed (Hibernate) when system operation is suspended,
depending on how your system is configured. At this point, programs that were running are stopped, active data
is saved, and the system enters one of two different low-power states, or sleep modes, as explained in the
following paragraphs.
I
F YOU ARE REPLACING THE BATTERY
ICON IS FLASHING BEFORE YOU REMOVE THE BATTERY
YOUR UNSAVED DATA
,
SETUP YOU SHOULD NOT REMOVE THE BATTERY UNLESS THE SYSTEM IS SHUT DOWN
ON LAN
3
Observe the Power icon in the Status display to determine which suspend mode your system is using.
• Power icon is blinking: Sleep mode.
In this mode, active data is saved by maintaining power to RAM while most other system
components are powered off. The Battery Gauge icon in the Status display indicates the battery
charge level.
• Power icon is not displayed: Hibernate mode.
In this mode, active data is stored on the hard disk drive and power usage is reduced to the same
level used in the Off state. When the system is in Hibernate mode, the Battery Gauge icon is not
visible in the Status display. In this mode, there is no danger of losing data if battery power is lost.
If you have successfully performed this procedure, system operation is now suspended. Refer to
"Resuming System Operation" later in this chapter to resume system operation. Also, note the
following with regard to suspending system operation:
. (N
OTE THAT IF THE
,
IS ENABLED THE BRIDGE BATTERY IS DISABLED IN ORDER TO OPTIMIZE BATTERY LIFE
51 - Starting the Tablet PC
,
WAIT UNTIL SYSTEM OPERATION IS SUSPENDED AND THE POWER
. F
AILURE TO DO SO COULD RESULT IN LOSS OF
R O LAN
ESUME N FUNCTION IS ENABLED IN THE
BIOS
. W R
HEN ESUME
.)