Technical Specifications - Intel SRCSASPH16I - RAID Controller Hardware Manual

Jumper
J6
J9
J11
J12
J13
J14
J15
J16
J17
J18

Technical Specifications

The design and implementation of the Intel
electromagnetic emissions, susceptibility to radio frequency energy, and the effects of
electrostatic discharge. See the appendices for regulatory marks and certifications.
13
Table 1. Jumper Descriptions
Description
Dirty Cache LED SFF8087
Header
Internal SAS/SATA SFF8087
port connector,
ports 4-7
Mode 0 select 2-pin
connector
Universal 4-pin
Asynchronous connector
Receiver/
Transmitter (UART)
Internal SAS/SATA SFF8087
port connector,
ports 0-3
Drive Fault LED 8x2 header
Header (0-7)
Port activity LED 8x2 header
header (0-7)
®
Intel RAID Smart 20-pin
Battery Connector connector
2
Keyed I C 3-pin
connector connector
2
Keyed I C 3-pin
connector connector
Type
For connection to enclusure LED. When lit,
indicates the data in the cache has not been
written to disk.
Connection to SAS/SATA devices.
No jumper is required for normal operation.
Setting the controller to Mode 0 holds the I/O
processor in reset for firmware recovery.
• "No Jumper = Normal operational mode.
• "Jumper = Mode 0 for firmware recovery,
requires a firmware recovery utility and
firmware image file.
For factory and debug use.
Connection to SAS/SATA devices.
LED signal support for front panel drive fault per
port (0-7).
LED signal for activity per port for 0-7 ports.
Cable connector for the extrernal battery pack.
This connector is located on the back side of the
board.
Out-of-band enclosure management (SES2).
Out-of-band enclosure management (SES2).
®
RAID Controller SRCSASPH16I minimizes
Intel® RAID Controller SRCSASPH16I Hardware Guide
Comments