Table of Contents
Advertisement
Configuring the Storage Adapter
After performing the Intel
configure the storage adapter and install the operating system driver. The Software User's
Guide instructs you on the configuration options and how to set them on your RAID
Controller SRCSASPH16I, and provides detailed installation instructions for operating
system drivers.
Replacing a Controller
Perform the following steps to replace a failed controller.
1. Power off the computer and all drives, enclosures, and system components. Remove
the power cord.
2. Remove the chassis cover and access the PCI Express add-in card slots. See your
server documentation for instructions.
3. Disconnect the cable(s) from the RAID controller.
4. Remove the failed controller from the system.
5. Insert the replacement controller into the system. Follow the instructions under
Installation.
Resolving a Configuration Mismatch
If a replacement RAID Controller SRCSASPH16I has a previous configuration, a
message displays during POST stating that there is a configuration mismatch. A
configuration mismatch occurs when the configuration data in the NVRAM and the hard
disk drives are different. You need to update the configuration data in the NVRAM with
the data from the hard disk drive.
Perform the following steps to resolve the mismatch.
1. Press <Ctrl> <G> when prompted during the boot process to access the BIOS
Configuration Utility.
2. Select Configure—>View/Add Configuration. This allows viewing of the NVRAM
and drive configurations.
3. Select the configuration on disk because the drives contain the correct configuration.
4. Press <Esc> and select YES to update the NVRAM.
5. Exit and reboot.
11
®
RAID Controller SRCSASPH16I installation, you must
Intel® RAID Controller SRCSASPH16I Hardware Guide
Advertisement
Table of Contents
