Diagnostic Features; Led Labels And Colors; Controller Jumper Settings; Led Descriptions - Intel SRCS14L - RAID Controller User Manual

Table 2. Controller Jumper Settings
Jumper Block
J1 - IOP mode select jumper block: This jumper is used to place the IOP in reset, which enables the
flash chip to be programmed to recover resident firmware (FW). This is only necessary if the
content of the flash part is corrupted and needs to be erased and reprogrammed. The jumper is
installed on pins 1-2 to enable this function. During normal operation and during normal firmware
updates, the jumper is installed on pins 2-3 (or removed totally).
J4 - PCI bus speed: Leave this jumper in the default position (pins 2-3 to auto-negotiate 33/66
Mhz) unless instructed to do otherwise by customer support or a specification update.
2.2.9

Diagnostic Features

The SRCS14L has LED indicators and audible beep sequences at startup to help you understand
the status of the controller.
Figure 3. LED Labels and Colors
A:0 A:1
Table 3. LED Descriptions
LED
A:0
A:1
B:0
B:1
T
S
P
P66
Technical Product Specification
Jumper Position
Jumper on pins [1-2]
J1
Jumper on pins [2-3]
No jumpers
Jumper on pins [1-2]
J4 Jumper on pins [2-3]
No jumpers
B:0 B:1 T S P
Indicates activity on SATA port A:0.
Indicates activity on SATA port A:1.
Indicates activity on SATA port B:0.
Indicates activity on SATA port B:1.
Indicates data transfer to the controller's cache memory.
When illuminated, the controller's IOP is in reset mode.
When illuminated, the controller card is powered on.
When illuminated, PCI bus frequency is 66Mhz. When not illuminated, PCI bus frequency is
33Mhz.
Intel® Integrated RAID Controller SRCS14L
IOP is in reset mode with firmware recovery
enabled.
IOP is in normal run mode.
IOP is in normal run mode.
PCI bus is forced to 33 MHz.
PCI bus auto-negotiates 33 MHz or 66 MHz.
PCI bus auto-negotiates 33 MHz or 66 MHz.
P66
Description
Definition
11